DKU-5改造成TTL

其实最近有很多东西想发上来,可惜一直偷懒,呵呵。一点点发把,先放几张小图给你们看看。












为了玩DIY路由,我可费了不少功夫,这次先完成了一根DIY的TTL数据线,通过的对诺基亚的DKU-5数据线改装,做成了一根USB的TTL线,很好用的说,哈哈。
看我用这根线读取电信送的DB108的启动信息,原来电信送的DB108这样的小破猫也是很强大的一个小路由,哈哈。


CFE version 1.0.37-0.7 for BCM96338 (32bit,SP,BE)                                                
Build Date: Wed Jul 27 16:40:09 EDT 2005 (root@localhost.localdomain)                                                                    
Copyright (C) 2000,2001,2002,2003 Broadcom Corporation.                                                      

Initializing Arena.                  
Initializing Devices.                    
Auto-negotiation timed-out                          
10 MB Half-Duplex (assumed)                          
CPU type 0x29010: 240MHz                        

Total memory used by CFE:  0x80401000 - 0x80522990 (1186192)                                                            
Initialized Data:          0x8041ACB0 - 0x8041C330 (5760)                                                        
BSS Area:                  0x8041C330 - 0x80420990 (18016)                                                          
Local Heap:                0x80420990 -                                      
Stack Area:                0x80520990 - 0x80522990 (8192)                                                        
Text (code) segment:       0x80401000 - 0x8041ACA8 (105640)                                                          
Boot area (physical):      0x00523000 - 0x00563000                                                  
Relocation Factor:         I:00000000 - D:00000000                                                  

Board IP address                : 192.168.1.1:ffffff00                                                      
Host IP address                 : 192.168.1.100                                              
Gateway IP address              :                                
Run from flash/host (f/h)       : f                                  
Default host run file name      : vmlinux                                        
Default host flash file name    : bcm963xx_fs_kernel                                                    
Boot delay (0-9 seconds)                                
Board Id Name                   : 96338L-2M-8M                                              
Psi size in KB                  : 24                                    
Number of MAC Addresses (1-32)  : 11                                    
Base MAC Address                : 00:08:5c:5f:9c:87                                                  
Ethernet PHY Type               : Internal                                          
Memory size in MB               : 8                                  

*** Press any key to stop auto run (1 seconds) ***                                                  
Auto run second count down: 0                            
Code Address: 0x80010000, Entry Address: 0x80175018                                                  
Decompression OK!                
Entry at 0x80175018                  
Closing network.                
Starting program at 0x80175018                              
Linux version 2.6.8.1 (root@localhost.localdoma                                              
l 29 20:49:57 EDT 2005                      
Total Flash size: 2048K with 35 sectors                                      
Scratch pad is not used for this flash part.                                            
96338L-2M-8M prom init                      
CPU revision is: 00029010                        
Determined physical RAM map:                            
memory: 007a0000 @ 00000000 (usable)                                    
On node 0 totalpages: 1952                          
  DMA zone: 1952 pages, LIFO batch:1                                    
  Normal zone: 0 pages, LIFO batch:1                                    
  HighMem zone: 0 pages, LIFO batch:1                                    
Built 1 zonelists                
Kernel command line: root=31:0 ro noinitrd                                          
brcm mips: enabling icache and dcache...                                        
Primary instruction cache 16kB, physically tagged, 2-w                                                    
Primary data cache 8kB 2-way, linesize 16 bytes.                                                
PID hash table entries: 32 (order 5: 256 bytes)                                              
Using 120.000 MHz high precision timer.                                      
Dentry cache hash table entries: 2048 (order: 1, 8192 bytes)                                                            
Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)                                                          
Memory: 6076k/7808k available (1244k kernel code, 1712k reserved, 179k data, 68k                                                                                
init, 0k highmem)                  
Calibrating delay loop... 235.52 BogoMIPS                                        
Mount-cache hash table entries: 512 (order: 0, 4096 bytes)                                                          
Checking for 'wait' instruction...  unavailable.                                                
NET: Registered protocol family 16                                  
Can't analyze prologue code at 80145acc                                      
PPP generic driver version 2.4.2                                
NET: Registered protocol family 24                                  
Using noop io scheduler                      
bcm963xx_mtd driver v1.0                        
brcmboard: brcm_board_init entry                                
bcm963xx_serial driver v2.0                          
NET: Registered protocol family 2                                
IP: routing cache hash table of 512 buckets, 4Kbytes                                                    
TCP: Hash tables configured (established 512 bind 1024)                                                      
NET: Registered protocol family 1                                
NET: Registered protocol family 17                                  
Ebtables v2.0 registered                        
NET: Registered protocol fami                            
NET: Registered protocol family 20                                  
VFS: Mounted root (squashfs filesystem) readonly.                                                
Freeing unused kernel memory: 68k freed                                      
init started:  BusyBox v1.00 (2005.07.30-00:53+0000) multi-call binary                                                                      
Algorithmics/MIPS FPU Emulator v1.5                                  


BusyBox v1.00 (2005.07.30-00:53+0000) Built-in shell (msh)                                                          
Enter 'help' for a list of built-in commands.                                            


Loading drivers and kernel modules...                                    

atmapi: module license 'Proprietary' taints kernel.                                                  
blaadd: blaa_detect entry                        
adsl: adsl_init entry                    
Broadcom BCMPROCFS v1.0 initialized                                  
Broadcom BCM6338A2 Ethernet Network Device v0.3 Jul 29 2005 20:47:09                                                                    
Config Internal PHY Through MDIO                                
BCM63xx_ENET: Auto-negotiation timed-out                                        
BCM63xx_ENET: 10 MB Half-Duplex (assumed)                                        
eth0: MAC Address: 00:08:5C:5F:9C:87                                    
Broadcom BCM6338A2 USB Network Device v0.4 Jul 29 2005 20:47:11                                                              
usb0: MAC Address: 00 08 5C 5F 9C 88                                    
usb0: Host MAC Address: 00 08 5C 5F 9C 89                                        
BcmAdsl_Initialize=0xC00551B8, g_pFnNotifyCallback=0xC0067CB4                                                            
AdslCoreHwReset: AdslOemDataAddr = 0xA07E504C                                            

==>   Bcm963xx Software Version: 3.00L.03.A2



最近做的事情有不少,最近还要帮网络美女SASA架设她的个人网站。HOHO
以后慢慢发出来吧,希望各位朋友继续支持我哦!我把我的DB108小破猫都刷了,o(∩_∩)o...哈哈


上一篇: 使用BT3+SPOONWEP2搞定了邻居家的WEP
下一篇: 对鼠标的测试
文章来自: 本站原创
引用通告: 查看所有引用 | 我要引用此文章
Tags: 路由 TTL线 手机数据线改装
相关日志:
评论: 0 | 引用: 0 | 查看次数: 27563
发表评论
昵 称:
密 码: 游客发言不需要密码.
邮 箱: 邮件地址支持Gravatar头像,邮箱地址不会公开.
网 址: 输入网址便于回访.
内 容:
验证码:
选 项:
虽然发表评论不用注册,但是为了保护您的发言权,建议您注册帐号.
字数限制 1000 字 | UBB代码 开启 | [img]标签 关闭